- On the 2001 Honda Forza MF 06, after 15,000 km, the suspension bearing of the right rear wheel hummed. Replaced with NTN products. After that I drove 3000 km, I'm happy with the result. When pressing ...Read More
- Fits:
- YAMAHA TT-R110E 08- [Number of genuine links]90
- YAMAHA RZ50 81-89 [Number of genuine links]106
- YAMAHA RX80 81 [Number of genuine links]110
- YAMAHA RX50 80-81 [Number of genuine links]110
- YAMAHA RD50 81-87 [Number of genuine links]112
- ...and more.
This chain is used on a Honda MTX 50 and is used in tough off-road conditions. In the mountains, in swampy areas, when overcoming water obstacles up to 0.5-0.6 m deep, the DID STD Series Chain 420D St...Read More - After 10 years of operation of the maxiscurator, the grease dried up in the drain bearings and they became unusable. A play appeared on the wheel. I replaced them with Koyo bearings. I need to remove ...Read More
- On my Honda NSS 250 mf 06 maxiskooter, when the steering wheel was turned too hard, the windshield was touched by the risk of breaking it off. I installed the Ai-net Mirror Adapter (10 mm thread, 1.25...Read More
- Fits:
- SUZUKI RANDY(FM50) *Required number:1
- SUZUKI JR50 78 *Number of units required:1
- SUZUKI K125 80-94 *Number of pcs required:1
- SUZUKI K90 67-91 *Number of pcs required:1
- SUZUKI K125 95 *Number of units required:1
- ...and more.
Iridium candle was installed on a 2-stroke air cooling Suzuki K 125 motorcycle. The engine on it starts confidently, works well both at medium (3500-4500) and at high speeds (7000-8000). There are no ...Read More - I installed this tubeless tire on the rear wheel of a Honda GL 700.There is 1-1.5 cm distance to the left and right pendulum. The sides are rigid, which makes it very difficult to mount the tire on th...Read More
- Шина на заднее колесо Honda GL 700 встала хорошо, маятник не задевает. Дорогу держит нормально.Резина ,хоть и изготовлена 3 месяца назад,на ощупь не очень мягкая,на тяжелом мотоцикле сотрется не так б...Read More
- Приобрел данное приспособление для стопорения шкивов скутера (максискутера) при откручивании гаек на осях вариатора и торкдрайвера.Покупкой доволен!Очень полезный инструмент для замены ремня вариатора...Read More
- Fits:
- HONDA FORZA MF06 [stock number]22123-KPB-000 piece6 [model name]NSS250Y/NSS2501/NSS2502/NSS250AY/NSS250A1/NSS250A2/NSS2503/NSS250A3/NSS250C3 [type]J/3J/4J/YA/YB/YC YE/YS
Ролики NTB поставил вместо изношенных стоковых.Большой разницы не ощущается между этими и оригинальными.Максискутер имеет быстрое ускорение до 100 км/час.
I put NTB rollers instead of worn out stoc...Read More - MINIMOTO Universal Holder-A very good tool for locking the bell of the front or rear scooter variator when unscrewing nuts in a garage environment.Read More
- Fits:
- HONDA FORESIGHT MF04
- HONDA FORZA(MF06)
ai-net OEM Type Disc Rotor&Brake Pads Set-хороший недорогой комплект из диска и колодок.Торможение плавное,предсказуемое.
ai-net OEM Type Disc Rotor & Brake Pads Set - a good inexpensive set of dis...Read More - Fits:
- SUZUKI
- SUZUKI Sky Wave 250 (CJ41A)
- SUZUKI
- SUZUKI
- SUZUKI
- ...and more.
MADMAX Grip установил на Honda Forza NSS 250.На ощупь мягкие,изделие состоит из резины.Руль держать удобно,хват хороший.
MADMAX Grip installed on the Honda Forza NSS 250. Soft to the touch, the pro...Read More - Установил фильтр в Honda Forza NSS 250.Стоит в коробке воздухоочистителя плотно.Подсоса пыли через уплотнения нет.
I installed the filter in the Honda Forza NSS 250. It is tight in the air cleaner ...Read More - Fits:
- HONDA FORZA(MF06)
- HONDA FORZA(MF08)
This product looks like the original. It adheres to the plastic very firmly. For 3 months of operation of the moped, the appearance of the logo has not changed.
Read More - Fits:
- HONDA FORZA MF06 [stock number]22123-KPB-000 piece6 [model name]NSS250Y/NSS2501/NSS2502/NSS250AY/NSS250A1/NSS250A2/NSS2503/NSS250A3/NSS250C3 [type]J/3J/4J/YA/YB/YC YE/YS
These variator products allow the drive belt to reach its maximum outer radius quickly. They are made of durable, wear-resistant material.Read More - Fits:
- SUZUKI RANDY(FM50) *Required number:1
- SUZUKI JR50 78 *Number of units required:1
- SUZUKI K125 80-94 *Number of pcs required:1
- SUZUKI K90 67-91 *Number of pcs required:1
- SUZUKI K125 95 *Number of units required:1
- ...and more.
Установил DENSO Iridium Power Plug IWF16 на Suzuki K 125.Двигатель работает ровно на различных режимах.Качество изделия хорошее.Пропусков искры в зажигании нет.
Installed DENSO Iridium Power Plug I...Read More - Fits:
- HONDA FORZA(MF06) MF06
- HONDA FORZA(MF06) MF06 [Fitting and other information]X
Установил ремень вариатора на Honda Forza (MF 06).Качество материала хорошее,износостойкий .Легко позволяет набирать скорость 120 км/час.
Established a variator belt on Honda Forza (MF 06). Materia...Read More - Приобрел фонари для Honda MTX-50.Внешне они почти не отличаются от оригинальных,к тому же они имеют подвижность и не ломаются от малейшего удара.
I bought lights for the Honda MTX-50. Outwardly, th...Read More - Fits:
- HONDA CHALY 50 CF50
- HONDA LIVE DIOZX
- HONDA MAGNA50
- HONDA LEAD 50
- SUZUKI ADDRESSV125 (G)
- ...and more.
Установил на Suzyki K125.При невысокой цене довольно хорошее качество продукта.Зеркала хорошо настраиваются,не дребезжат.
I installed it on a Suzyki K125. At a low price, the product quality is qui...Read More - Fits:
- SUZUKI LETS II (2Cycle) 01-07 Stock main jet number #68|#72
- SUZUKI LETS4 01-07 Stock main jet number #68|#72
- HONDA solo 03 Stock main jet number #62
- HONDA DAX -98 Stock main jet number #60
- HONDA APE 100 09 Stock main jet number #65
Набор из шести жиклеров позволяет точно настроить топливо-воздушную смесь карбюратора KEIHIN при работе на максимальных оборотах.
A set of six jets allows you to fine-tune the fuel-air mixture carb...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING