2nd order of this as it looks good. Got a few Beet bits on my bike so added a couple of stickers. Application was good. Strong adhesive.
View Detail
10.83 EUR (1,870 JPY)
Webike Point: +19 pt
(0.11 EUR)
Delivery Information
-
Please select product form first.
Product detail
Font size: Width 48mm X Height 105mm
Heat resistant temperature: Approx. 100 degrees
**The heat resistance temperature is approx. 100 degrees.Do not use the product in a place where the temperature is higher than that.There is a possibility of discoloration at high temperature.
*Image 2 shows an example of installation on a silencer..
One-touch transfer type heat resistant sticker with same letters as NASSERT-REvolution exhaust used by Team Green in All Japan Championship JSB class.
It can be used not only as a silencer but also as a one point of the cowl.
It can be attached to places with a width of 50mm or more.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
NEW ARRIVALS IN USED PARTS FOR
New arrivals in used
New arrivals in used
Customer Reviews
Reviews with image
Installed on: KAWASAKI Z900RS
Installed on: KAWASAKI Z900RS
Dec 20, 2024
Stickers look good quality. Laser cut. Not sure where I will put them yet. But wanted the stickers as I have Beet bars fitted to my bike.
View Detail
Helpful?
Installed on: KAWASAKI Z900RS
Dec 4, 2024
Customisable with a little imagination
With a little minor modification & combination with another sticker I was able to create a custom statement that is hopefully not too bold.
View DetailHelpful?
Oct 8, 2020
Because it is a heat-resistant Sticker, it can be attached to Silencer, and the silencer of BEET becomes more parenthesis good. The fastest itself is also parenthesis good and I like it.
View DetailHelpful?
Oct 4, 2020
There seems to be a Rose variation in quality.
I finally succeeded for the fifth time.
The first time, when I removed it from the backing paper, it got stuck in the backing paper and the letters were torn.
The second one is the same as the first one.
The third time, I was traumatized and although I did not leave any residue on the mount, I rubbed the film well so that it would stick firmly to the exhaust system, but it did not peel off from the film and the letters were torn.
The fourth one is the same as the third one.
The fifth time, it peeled off from the base properly, and stuck to Exhaust System, and when I did the rubbing of the Film properly with a surcease, it stuck without dismay.
Each piece is not cheap, so I wasted a lot of money.
I like the Design very much.
Helpful?
New Custom Articles
