RAPiD BIKE-EASY Kit

[How is it used?
i installed it on klx250
The vehicle is equipped with FMF Slip-on Silencer, otherwise NORMAL.

Was the installation difficult?
It is easy to attach with Couplet-on, but I was quite confused about the position to fit SwitchBody and Wiring.
Instruction Manual is also included.

How was your experience with it?
I set the settings as specified in the Instruction Manual (2/+2).
The Slip-on Silencer at FMF had a bad AfterFirea, but it has almost completely subsided. (If it was originally 100, it was reduced to about 10.)
The car used to stall easily when starting off, but I think it is better now.
I don't feel any power up at the moment.

Please note that if you buy this product expecting excessive power-up, you will be disappointed.

这个五星是给Webike的。我的车是2019款KAWASAKI ZX-6r，买回来后发现和车不匹配。经过webike工作人员的热情服务，很顺利的完成了退货。非常感谢！----------------------------------------------The star is to Webike of. My car is a 2019 models KAWASAKI ZX-6r, to buy back the car and found a mismatch. After warm service webike staff, very smooth completion of the return. thank you very much!Powered by Google Translator

Replaced the Exhaust System with KFACTORY's Full Exhaust System It is easy to come out after changing to a good thing of Universal and Silencer The Torque was getting a little weak at the time, so I bought this product because it seems to be able to burn easily In the case of ZrX1200 DAEG, SETTING is 2 and FUEL RATIO is +2 It was mentioned in the Instruction Manual to set the setting to The torque became smooth and easy to ride, but there is still a little bit of after When I increased the RATIO to +3, the after disappeared, but the vibration to the car body came out The installation of the body is done by Seat Cowl It's SMART to put underneath, but I can always check the power lamplight and fuel tone The extra Wiring is fixed to the rear under the Seat so that the setting can be changed, and the Body is fixed without a lid I stuck it with strong adhesive Double-sided Tape It is not cheap parts, but because the effect comes out with an unexpected hack drill Recommendation

Installation is very simple
I put the Full Exhaust System on the overhauled car and then I put the low speed Torque system on the Idol I was feeling a little bit difficult to ride in the city I was hesitant to buy it because it was a compatible product, but I thought it was possible to adjust it a little bit, so I hoped it would improve the fuel quality You can feel the change in the value recommended by the manufacturer The fine tuning was done while running for a little while A sense of stability of the low-speed has increased and the blown-up is perfect The AI should be cut

I didn't feel the need for it so much, but the body I used for other models was left over, so I decided to use it only for this I bought a Harness and used it...Only Harness is about 10,000 yen more expensive, but it is compatible with 250SL Translation of the settings listed (please enter here) feels good
The good thing about using it is that it is easier to open up from the partial because of the lighter or thicker fuel tone and low to medium speeds The connection between the two is improved, even if the rotation is depressed at places like the RightLeft turn at intersections I feel more comfortable with the beginning
The disappointing thing is that Only Harness is also relatively expensive at 10,000 yen, but I'm satisfied with the effect
The fuel consumption became about 35km/liter instead of 40km/liter, which is totally acceptable for the effect Within